Plain concrete

$75–$150

Per m², laid · typically $110

  • Standard grey concrete with a broom or trowel finish
  • The cheapest finish
  • Shows tyre marks and oil stains most

Coloured concrete

$95–$200

Per m², laid · typically $140

  • Colour mixed through the concrete or applied to the surface
  • The middle price
  • Colour can fade and patches are hard to match

Exposed aggregate

$120–$200

Per m², laid · typically $160

  • Surface washed back to show the stones
  • Dearest of the three
  • Textured, grippy and good at hiding marks

The short answer

Plain concrete is the cheapest at $75 to $150 per m². Coloured concrete is $95 to $200 per m² and exposed aggregate is $120 to $200 per m². The concrete underneath is much the same in all three. What you pay extra for is the finishing work and, for exposed aggregate, the decorative stone mix.

  • Choose plain for side paths, shed slabs and anywhere looks do not matter.
  • Choose coloured to lift a path or patio without the full cost of exposed aggregate.
  • Choose exposed aggregate for a front driveway, where grip and hiding tyre marks matter most.

Price per square metre

FinishLowTypicalHighBasis
Plain concrete$75$110$150per m²
Coloured concrete$95$140$200per m²
Exposed aggregate$120$160$200per m²
Concrete path$75$110$160per m²
Concrete patio or entertaining area$80$125$180per m²

National price bands from the price table in our concreting cost guide, GST included. City pages carry the prices for your city.

Worked example: a 40 m² driveway

A 40 m² driveway, about enough for two cars side by side, priced in each finish at the typical rate.

FinishWorking (typical rate)At the typical rateLow to high
Plain concrete40 × $110$4,400$3,000–$6,000
Coloured concrete40 × $140$5,600$3,800–$8,000
Exposed aggregate40 × $160$6,400$4,800–$8,000

40 m² × the per-square-metre rate in our national concreting table. Our table also carries a whole-job row for an exposed aggregate driveway: $4,800 to $9,000. Breaking out and removing an old driveway is extra ($30 to $100 per m²).

Why the finish changes the price

All three start the same way: the ground is prepared, formwork and steel go in, and the concrete is poured. Plain concrete is then finished with a broom or trowel. Coloured concrete adds the pigment and more care to keep the colour even across pours. Exposed aggregate uses a decorative stone mix, and the surface is washed back at the right moment to reveal it, then sealed. That timing is skilled work, which is why it is the dearest finish.

Exposed aggregate vs coloured vs plain: for and against

Plain

For

  • Lowest price
  • Any concreter can lay it
  • Easy to patch or extend later

Against

  • Shows oil, tyre marks and stains
  • Plain grey look
  • Smooth finishes can be slippery when wet

Coloured

For

  • A finished look for a modest premium
  • Wide choice of colours
  • Works well on paths and patios

Against

  • Colour can fade in strong sun
  • Later pours and repairs rarely match
  • Still shows stains on light colours

Exposed aggregate

For

  • Hides marks and wear
  • Textured surface gives grip on slopes
  • Looks like a premium finish from the street

Against

  • Highest price of the three
  • Needs resealing to keep its look
  • Rougher underfoot for bare feet

Which should you choose?

To size the job, the concrete calculator works out cubic metres and prices a driveway for your city. If you are also weighing pavers, see our concrete vs paver driveway guide.

Frequently asked questions

Is exposed aggregate more expensive than plain concrete?

Yes. Plain concrete is $75 to $150 per m² and exposed aggregate is $120 to $200 per m² on our national table. Coloured concrete sits between them at $95 to $200 per m².

How much does a 40 m² exposed aggregate driveway cost?

At the typical rate on our national table, 40 m² of exposed aggregate comes to $6,400 (40 × the typical rate), with a range of $4,800–$8,000. The same driveway in plain concrete comes to $4,400.

Is coloured concrete cheaper than exposed aggregate?

At the typical rate, yes: coloured concrete is $95 to $200 per m² and exposed aggregate is $120 to $200 per m² on our national table.

What does it cost to remove an old concrete driveway?

Old concrete removal, including disposal, is $30 to $100 per m² on our national table.

Which concrete finish is best for a sloping driveway?

Exposed aggregate. Its textured surface gives tyres and shoes more grip than a smooth plain or coloured finish. A broom finish on plain concrete is the budget alternative.

Know which finish you want? Get quotes from local concreters and compare them against the rows above.

Get concreting quotes →

Where these figures come from

Every price on this page is a row of the national price table in the cost guide named below, so it moves when that guide is re-priced. Worked examples are a stated size multiplied by a row, with the working shown. This page makes no claim that is not a price or a plain description of the products. Prices are guides, not quotes: your site, access and finish level decide the figure.

  1. Prices: the national price table in our concreting cost guide, checked November 2026

Related guides