How much do commercial garage doors cost in Darwin?
A commercial garage door in Darwin costs $3,100–$27,000 installed, from an industrial roller shutter at the entry point to a high-speed rapid-roll door at the top. For roller doors the size and the motor do most to set the price: a motorised door for a 3m x 3m opening is $4,650–$7,200 installed, and for a 5m x 5m opening $8,300–$12,700.
Demand comes mainly from sheds, workshops and depots in the industrial suburbs and at the port, plus storage units and service bays across Palmerston and the northern suburbs. In the tropics a door has to cope with storms, humidity and long run times, so when quotes differ, check that the curtain gauge, wind locks and fixings match before comparing price.
Sectional doors run $3,750–$21,400 installed and insulated panels $295–$400 per m² supplied, both ex GST, as are rapid-roll doors; roller door and shutter prices include GST. Servicing each door costs $160–$375 a year.
Comparing cities, or after the Australia-wide picture? See the national guide: How much do commercial garage doors cost in Australia?
Commercial Garage Door Prices in Darwin 2026: Cost Table and Price List
| Service | Low | Typical | High |
|---|---|---|---|
| Industrial roller shutter (per door, installed) | $3,100installed | $4,850 | $12,950 |
| Insulated commercial door (PU-core sectional, supply only, per sqm of door, ex GST) | $295/sqm | $345 | $400 |
| Commercial sectional overhead door (installed, ex GST) | $3,750installed | $10,500 | $21,400 |
| High-speed / rapid-roll door (supply + install, ex GST) | $11,900supply+install | $16,200 | $27,000 |
| Roller door ~3m x 3m, manual (installed) | $3,350installed | $4,050 | $5,100 |
| Roller door ~3m x 3m, motorised (installed) | $4,650installed | $5,700 | $7,200 |
| Roller door ~4m x 4m, motorised (installed) | $6,500installed | $7,700 | $9,700 |
| Roller door ~5m x 5m, motorised (installed) | $8,300installed | $9,700 | $12,700 |
| Door motor / operator replacement | $810per door | $1,350 | $2,700 |
| Annual door service (per door) | $160per year | $270 | $375 |
You're in.
A local installer will be in touch about your job. No spam, no call centre.
Scoping a commercial garage door? Get a quote from an Australian commercial door installer — free, no obligation.
Get commercial quotes →Prices include GST unless the row says ex GST. Darwin-wide, November 2026. Large or custom openings vary.
Darwin roller shutter and commercial garage door prices by door type
A Darwin roller shutter is specified differently from one anywhere further south, and the price list reflects it: every door type below is costed for wind pressure, the wet season and the salt that blows in off the harbour.
- Industrial roller shutter: $3,100–$12,950 installed. The cyclone-rated curtain, heavier guides and anchorage that a Berrimah or East Arm freight shed needs explain why the typical door is $4,850.
- Standard roller doors: $3,350–$5,100 installed for a manual 3 m x 3 m door, $4,650–$7,200 installed motorised, $6,500–$9,700 installed at about 4 m x 4 m and $8,300–$12,700 installed at about 5 m x 5 m.
- Commercial sectional overhead door: $3,750–$21,400 installed, ex GST. Yarrawonga and Palmerston dealerships choose it for glazed, insulated panels that keep a cooled showroom bearable through the build-up.
- High-speed rapid-roll door: $11,900–$27,000 supply and install, ex GST, for the seafood exporters and cold stores at the port where humid air must stay out of the chiller.
- Insulated PU-core door: $295–$400 per m² of door, supply only, ex GST; the door that pays for itself fastest where air-conditioning runs all year.
- Operator and upkeep: $810–$2,700 per door for a replacement operator and $160–$375 a year for each door serviced.
Use the form on this page to get quotes from commercial garage door installers in Darwin.
Commercial vs residential garage doors — why commercial costs more
Every new garage door in Darwin, house or commercial, must comply with AS/NZS 4505, so the gap comes from scale and duty. A warehouse curtain at a Berrimah depot spans far more area than a suburban car-space door, which means a heavier curtain, stronger guides, often with wind locks, and firmer anchoring into the structure. Commercial doors also cycle through long shifts in heat and humidity, so the operator and springs are rated for heavy use, and the drive is often three-phase, which a house door rarely uses.
Commercial garage door sizes and how size drives price
Each step in opening size adds cost, because the curtain has to be heavier and better anchored as it grows. Motorised, a roller door near 3m x 3m runs $4,650–$7,200 installed, near 4m x 4m $6,500–$9,700, and near 5m x 5m $8,300–$12,700. A manual door at the smallest size is $3,350–$5,100 installed. Wind pressure acts on the whole face of the door, so a wider curtain asks more of its guides and wind locks. Have the installer confirm what the guides will fix into, steel portal frame or blockwork, since the anchorage of a rated door depends on it.
What Actually Moves the Commercial Garage Door Cost in Darwin
- Cyclone rating. Darwin is in AS/NZS 1170.2 wind region C, so the door's design wind class, its wind locks, guides and anchorage set a large part of the price.
- Wet-season wear. Humidity and monsoon rain corrode springs, axles and fixings, so coated hardware and sealed operators cost more at the start but hold out longer.
- Dry-season dust. Fine dust packs into guides and bottom seals through the dry, and doors on unsealed yards need brushes and more frequent cleaning.
- Power and backup. Storm power cuts can leave a heavy door stuck open, so a battery backup or easy manual release adds cost but lets the site close up.
- Duty and heat. Doors at port, transport and logistics yards run long shifts in high heat, and an operator rated for that duty costs more than a light-use unit.
How to Keep the Commercial Garage Door Cost Sane in Darwin
Commercial garage door cost by door type
In Darwin the wind rating comes before the door type. Every new external garage or large access door has to meet AS/NZS 4505, so compare shutters and sectionals for an outside wall at the same wind class before comparing price. A roller shutter secures a yard or shed for the least outlay. A sectional suits an air-conditioned showroom or office that wants an insulated, glazed frontage. Rapid-roll doors belong on internal openings between cold rooms and dispatch, where speed keeps humid air out.
Our Methodology
Commercial pricing on this page is compiled from Australian commercial and industrial garage-door suppliers and installers, published supplier price guides and product ranges as of November 2026. We cross-reference ranges from multiple sources; no contractor can influence a published figure. All prices are estimates, GST-inclusive unless a row says ex GST, and will vary with your specific opening, door spec and site. Always get multiple written quotes. Last reviewed November 2026. Read our full methodology →
Commercial garage door prices, product by product
Industrial roller shutters in Darwin cost $3,100–$12,950 installed, typically $4,850. Width comes first, then the wind class, curtain gauge and wind locks, then a single-phase or three-phase operator. A small shutter inside a shed lands low in the band; a wide, cyclone-rated door on a truck entry at East Arm or Pinelands sits near the upper figure.
Commercial sectional overhead doors run $3,750–$21,400 installed ex GST, typically $10,500. An insulated PU-core sectional is $295–$400 per m² of door, supply only and ex GST, so a door about 5m wide and 4m high comes to $5,900–$8,000 supplied, with installation quoted on top.
High-speed rapid-roll doors are $11,900–$27,000 supplied and installed ex GST, typically $16,200. Seafood processors, cold stores and food distributors use them where forklifts cross between a chilled room and a hot dock all day. The fabric curtain opens and shuts in seconds, which keeps humid air and condensation off the cold side.
A tired operator costs $810–$2,700 per door to replace, and servicing runs $160–$375 a year for each door. Ask the technician to check that wind locks engage along the full height of the guides, that fixings into the frame are tight and free of rust, and that the door reverses when it meets an obstruction. After a severe storm, have the anchorage and guides checked before the door goes back into daily use.
Commercial garage doors — go deeper





Which door for which job?
Transport yards, machinery sheds and storage at Winnellie, Pinelands and Yarrawonga: a cyclone-rated roller shutter with wind locks gives security and storm resistance for the lowest installed price.
Showrooms, dealership workshops and air-conditioned offices: an insulated sectional door keeps the cooled space comfortable, shuts out the afternoon heat and presents a neater frontage to customers.
Seafood, meat and produce cold chains around Frances Bay and East Arm: a rapid-roll door on the chiller opening, with a rated shutter on the outside wall to close the building when a cyclone warning comes.
Red flags when comparing commercial door installers
- No AS/NZS 4505 compliance or design wind class stated for a new external garage or access door.
- No explanation of how the curtain is held in its guides under wind load, such as wind locks.
- Fixings into the frame or slab not described, leaving the anchorage to be worked out on the day.
- A price for bracing an old door with no detail of the posts, brackets and who fits them before a cyclone.
- Plain hardware offered for a site exposed to salt air or wet-season humidity.
Roller door sizes and prices in Darwin
Darwin roller door quotes are shaped by the opening and by the wind rating the door is built to. A 3m x 3m door costs $3,350–$5,100 installed when manual and $4,650–$7,200 installed when motorised. For a light truck bay at Berrimah, a motorised door near 4m x 4m runs $6,500–$9,700 installed, with heavier curtains and wind locks pulling a job toward the upper figure of each row.
Wet-season humidity is hard on springs, bearings and motors, so running costs deserve a line in the budget. An annual service is $160–$375 a year per door, and booking it before the wet helps a door close cleanly when storms arrive. A worn operator is replaced at $810–$2,700 per door, with a heavier-duty or sealed unit sitting toward the upper figure.
A transport yard often wants taller openings. A motorised door near 5m x 5m is $8,300–$12,700 installed, so two of them on a Winnellie truck shed come to $16,600–$25,400 installed. Heavy-use bays with forklifts through them all shift tend to be priced as an industrial roller shutter instead, at $3,100–$12,950 installed, typically $4,850.
Commercial garage door cost in Darwin for cyclone-season sites
Commercial roller door prices in Darwin sit at the upper end nationally, and doors here are often specified with heavier curtains, wind locks and stronger fixings for the cyclone season. A manual roller door around 3m x 3m costs $3,350–$5,100 installed, and the same size motorised runs $4,650–$7,200 installed, typically $5,700. A motorised 4m x 4m door costs $6,500–$9,700 installed and a 5m x 5m motorised door $8,300–$12,700 installed.
Industrial doors dominate in Winnellie, Berrimah, Yarrawonga and the East Arm port area, where truck and machinery openings are wide and doors run all day. Industrial roller shutters cost $3,100–$12,950 installed and commercial sectional doors $3,750–$21,400 installed ex GST. Sectionals suit sites where a roller drum would block a mezzanine or crane rail. Heat, humidity and monsoonal rain wear out motors and seals quickly, and dust in the dry season clogs guides.
Replacing a door motor costs $810–$2,700 per door, and an annual service runs $160–$375 a year per door, with the build-up a sensible time to book it. A good Darwin garage door quote should give the opening size, curtain gauge, any wind locks or wind rating stated for the door, the motor and backup battery, the fixing method to the structure, and what the service covers ahead of the wet.
What a Compliant Commercial Garage Door Quote Includes — Cost in Darwin
In Darwin a commercial garage door quote is only comparable once it states the cyclone and corrosion specification, the season the work is booked for and whether each figure is ex GST. Get those in writing before weighing one total against another.
- Door count and the clear opening of each, with the door type and curtain gauge named rather than described as commercial.
- The wind and debris loading the door, guides and anchors are specified for on this Darwin site, written as its own line.
- Fixing into the slab and lintel described, including anchor type, since tilt-up panels and blockwork in Palmerston and the industrial estates take different fixings.
- Booking and lead-time terms through the build-up and wet season, with what happens if monsoon rain closes the site.
- Corrosion protection for the tropics: coating, stainless or galvanised fasteners and sealed operator housings, and whether they sit in the base price.
- Installed and supply-only lines marked separately and labelled ex GST or inclusive; an industrial roller shutter installed runs $3,100–$12,950.
- Motor or operator swap on an existing door priced per door, $810–$2,700, with the make, phase and duty cycle named.
- Who commissions the door, who signs off and when, plus removal and disposal of the old curtain listed as included or extra.